500 gr. Hornady Reload Data?
Just picked some 500 grain JSP Hornady bullets for my S&W 500 mag., I was just wondering if anyone has tried to work up a load for the 50ae using this bullet. Is there enough case capacity? I...
View ArticleRe: 500 gr. Hornady Reload Data?
Havent seen any reload data for the 500gr, and I really dont think there is enough capacity in the 50AE case for it. But ballistic supply has some 700 gr. hardcast bullets for the 500S&W! I bet...
View ArticleRe: 500 gr. Hornady Reload Data?
Yeah!I've tried them..They are a Blast! (all pun intended)
View ArticleRe: 500 gr. Hornady Reload Data?
I would imagine that they would feed and fire, but you'd have to pay a lot of attention to the loads you use.If the bullets are too long, then getting enough powder in the case to cycle the slide...
View ArticleRe: 500 gr. Hornady Reload Data?
Well;I'm going to start working on a load for this, I think it can be done from what dimensions I have. It will probably take me about a month or so to come up with the right combination but I'll post...
View ArticleRe: 500 gr. Hornady Reload Data?
I had a 700 grain mould built by Mountain Molds for my .500 S&W's. With lube & gas check, it weighs it about 710 grains, and it isn't as bad to shoot as you might imagine. Ya gotta load it...
View Article